200M broadband speed measurement only 100M broadband speed limit reasons and solutions

I believe that many friends who upgrade broadband at home have such questions. Why did they measure the speed after broadband processing or upgrading to 200M optical fiber and found that only 200M broadband speed was only 100M, which obviously means that the broadband speed was not up to standard. Home below Share the reasons and solutions for broadband network speeds not up to standard.

200M宽带测速只有100M 宽带网速不达标原因及解决方法

Reasons for broadband network speed not up to standard

The reason why the broadband speed is not up to standard is not necessarily caused by problems with the broadband itself. It is more likely to be problems with your own hardware, such as the limitations of your network cable, router, optical cat, and network card. For example, your network card, network cable, etc. only supports 100M broadband.

If you have broadband of more than 100M, then you must meet the following hardware conditions:

1. Whether the motherboard is a gigabit network card

Generally speaking, if you are an old computer a few years ago, you will basically have a 100-megabyte network card. If you need to upgrade your computer in this case, of course, you can also buy a Gigabit wired network card with PCI and USB interfaces. However, all new computers purchased in recent years are Gigabit network cards.

200M宽带测速只有100M 宽带网速不达标原因及解决方法

Motherboard on-board rtl 8100c 100M network card chip

2. Does the network cable support gigabit?

Some users consider being cheap and choose some cheap network cables. These network cables support up to 100 megabytes of broadband and cannot enjoy network speeds above 100M. It is recommended to use a minimum of super five cable, which supports gigabit or less. Of course, Category six cable is better., it can support gigabit speeds or above.

200M宽带测速只有100M 宽带网速不达标原因及解决方法

3. Optical cats and routers support gigabit

Generally, when you apply for 200M broadband, the optical cat given to you by the operator will definitely support Gigabit. We can rule out that if your router also needs to support more than 100M, Gigabit routers have been popularized. If the router is too old, it is only 100M, so you can directly replace it.

200M宽带测速只有100M 宽带网速不达标原因及解决方法

The above are the reasons and solutions for the broadband network speed that is not up to standard shared by the Installation Home. If your broadband reaches more than 100M, if the network speed fails to meet the standard, it is undoubtedly due to hardware limitations. If your router, network cable, network card, optical cat, etc. all support Gigabit, but the network speed is still not up to standard, you can contact the network operator to help solve the problem.

Post a reply

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注