Shanghai Frank Muller Watch Repair Point [Frank Muller Watch Water Treatment]

The problem of water entering watches is common in daily life. Light cases will affect the perspective effect of the surface. When viewed from the outside, it will be white. In serious cases, it will affect the corrosion of parts inside the mechanical watch movement, reduce the lubrication of the mechanical watch, and affect the accuracy of the mechanical watch. How to solve this problem? Let Xiaobian give you a brief introduction

Since there is confusion in the mechanical watch mirror, of course there is water in the mechanical watch. Under normal circumstances, although mechanical watches are airtight, mechanical watches are composed of many parts, and extremely thin gaps will appear at the junction of various parts. If the mechanical watch is used for a long time, the gap will increase, increasing the possibility of water entering. This problem needs to be dealt with or repaired in time. In fact, most problems can be solved by themselves. The method is as follows. Shanghai Frank Muller Watch Repair Shop [Frank Muller Watch Water Treatment]-Watch Service Center

dehydratable dry

First prepare a pack of desiccant (the more desiccant, the better. Of course, some people say lime is okay, but I don’t recommend it, lime is not easy to operate) and a gas-tight container. The mechanical watch also pulls out the crown, and then mixes it with the desiccant. Put it in a prepared container that is waterproof and sealed. The time is related to the amount of desiccant, and the more it is, the shorter it will be. It is also feasible to use this method to remove fog from mechanical watches.

baking

The crown is used to adjust the timing and wind up the chain, but it is also an important way for a mechanical watch to be flooded. Whenever the watch is adjusted, the crown must be pulled out, which will lead to a certain gap. Pull the crown to first or second gear, wrap it in a tissue or cloth that absorbs water, and then use a 40W incandescent bulb (as long as it can heat it anyway), or under the strong sun, and observe while baking. It takes about half an hour to remove the fog.

Blow dry with fan

Prepare a hair dryer, first fix the mechanical watch on the side. The back cover of the mechanical watch is usually a stainless steel cover (of course, there is also a see-through cover). The crown still needs to be pulled out. After the hair dryer is powered on, adjust it to low (The temperature should not be too high, it will easily scorch the internal parts of the mechanical movement, and the wind speed should not be too high), blow at the metal position, and use the thermal conductivity into the movement to increase the temperature inside the movement, vaporize the water, and discharge it along with the gap in the crown. This method can be reused to ensure that no water is removed from the movement. Remember to be careful when using this method. cjq

The above is a brief introduction to the treatment of water inflow in a watch. The above method can only be applied to light water inflow. If the water inflow in a mechanical watch is too serious, the above hair cannot be completely removed. Then you need to send the watch to after-sales sales or repair center for processing, so as to avoid oxidation and corrosion of the internal movement parts of the mechanical watch, accelerate the aging of the mechanical watch and reduce its life. Shanghai Frank Muller Watch Repair Point [Frank Muller Watch Water Treatment]-Watch Service Center Details Click: Shanghai Frank Muller Repair Center-British Watch Certified

 

Post a reply

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注