What should I do if the Siemens water heater does not heat it? What are the common maintenance methods?

Heaters are not only used for space heating, but also for cooking, cleaning and showering. So what should I do if the Siemens water heater does not heat it during use? What are the common maintenance methods? Continue reading, the following is an analysis of the causes of non-heating and common failures in Siemens water heaters.

The following are the reasons and solutions why Siemens water heaters do not heat:

西门子热水器不加热

Phenomenon 1: No insulation function

Reason: The temperature is too high, the line burns; Treatment: Replace the thermostat

Phenomenon 2: Electricity leaks after filling up water

Reason: The heating pipe is damaged and leaking electricity; Treatment: Replace the heating pipe.

Phenomenon 3: The indicator light is normal but cannot be heated

Reason: Poor contact at the connector end of the heating pipe or burnt out the heating pipe; Treatment: Check and eliminate it, and replace the heating pipe;

Phenomenon 4: The heating indicator light is abnormal and cannot be heated

西门子热水器不加热

Reason: Poor contact of the thermostat plug or disconnection; Treatment: Check and eliminate it to see if the thermostat needs to be replaced.

Phenomenon 5: The water heater indicator light never goes out

Reason: The temperature-sensitive surface of the thermostat rarely comes into contact with the flange surface of the electric heating pipe; Treatment: Replace the thermostat

Common maintenance methods:

1. Leak repair: If you find water near your equipment, call the plumber immediately. A water heater leak can cause flooding in your home, and you need to repair it before it reaches this level of damage.

西门子热水器不加热

2. Regular flushing: Over time, metal deposits can build up in the water heater. This not only causes problems with hard water, but also affects the efficiency of the tank. Rinse the water heater regularly to keep it running properly.

3. Replace the anode rod: The rod will be damaged and needs to be replaced, otherwise the water tank will start to rust.

4. Install a thermal expansion tank: If the water heater leaks frequently, the water pressure may be too high. A thermal expansion tank and a pressure relief system can be installed to protect the heater from further damage.

5. Temperature adjustment: If your water is too hot or not hot enough, you may need to adjust the thermostat on your device. For most homes, the ideal hot water temperature is between 55 and 65 degrees.

Post a reply

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注