How to restore the factory settings of the 360 router?

Question:How to restore the factory settings of the 360 router?

a: Find the Reset button on the 360 router. When your 360 router is powered on, press and hold the Reset button for about 5 seconds; at this time, pay attention to the status of the indicator light. When the indicator light flashes again, it means that the factory settings have been restored successfully.

360路由器恢复出厂设置怎么弄?

Note:

(1) The Reset button on some 360 routers is in a small hole. You need to use small objects such as toothpicks, needles, and nibs to hold down the Reset button in the small hole.

(2) Please note that it takes a long time to press the Reset button for a few seconds, and it cannot be released in the middle; if it is released by pressing it once, your 360 router will not be restored to the factory settings in this case.

(3) During the process of restoring factory settings, do not disconnect the power to your 360 router, otherwise the router will be damaged.

(4) After the factory settings are successfully restored, all the previously set wifi name and password, Internet access parameters, administrator password and other parameters will be deleted. At this time, your 360 router cannot access the Internet.

Therefore, you must use your computer or mobile phone to log in to the settings page of the 360 router, reset the Internet access parameters, wifi name and password, and login password, and complete the settings before you can access the Internet normally. For setting steps, you can refer to the following article:

How to set the 360 router after restoring the factory settings?

Post a reply

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注