How to set up Tenda wireless router (Windows 8)

This article introduces the method of installing and setting up Tengda wireless router under Windows 8. A brand new Tengda wireless router needs to go through the following three configuration steps to complete installation and Internet setting up under Windows 8 computers:1. Install the router;2. Configure the computer IP;3. Configure the router。This article will use the Tengda N300 wireless router as an example to demonstrate how to install and configure a router.

Step 1: Install the router

1. Telephone line Internet users: Prepare2One network cable, one network cable is used to connect ADSL Modem(Cat) and Tengda N300 routerWANPort; another network cable is connected to any interface in the Tengda router’s LAN port (1/2/3/4) at one end, and connected to a Windows 8 computer at the other end.

腾达路由器与电脑、modem连接图

2. Household cable users: You only need to prepare a network cable, and first plug the network cable connected by the broadband operator to your home into the network of the Tengda N300 router.WANPort; then connect one end of the network cable you prepared to any of the LAN ports (1/2/3/4) of the Tenda router, and the other end to a Windows 8 computer.

网线入户时腾达路由器连接

Step 2: Configure the computer IP

1. Open the Control Panel: Click Settings–Click Control Panel”

Windows8电脑控制面板

2. Click on the Internet and Internet”

Windows8电脑中的网络和Internet选项

3. Click on the Network and Sharing Center”

Windows8电脑中”网络和共享中心“选项

4. Click Change Adapter Settings.

Windows8电脑中更改”适配器设置“

5. Right-click on Ethernet-click Properties.

Windows8电脑中以太网属性

6. Right-click Ethernet to select Properties and select Internet Protocol Version 4(TCP/IPv4) Click Properties (or double-click Internet Protocol Version 4(TCP/IPv4)”)。

选择Internet协议版本4

7. Check the options to automatically obtain ip addresses and automatically obtain DNS server addresses and click OK”

Windows8电脑中配置动态IP地址

Step 3: Configure the router

1. Enter: 192.168.0.1 in the browser’s address bar and press the Enter key—Enter the password in the page you jump to: admin —Click OK.(If 192.168.0.1 cannot be opened, please read the article:Solution to the Tenda wireless router 192.168.0.1 that cannot be opened

腾达路由器登录

2. Select ADSL dialing—-fill in the Internet account number and Internet password (which is the broadband account number and password provided by the broadband operator)—-Set a wireless password and click OK. The setting steps are as shown in the following figure:

Tenda路由器上网参数设置

3. Click Advanced Settings—-in the system state, check whether it shows whether it is connected and whether there is IP address and other information. If it does, it means that the setting has been successful, and computers, mobile phones and other terminals can share the Internet through the Tengda N300 router; if it shows No connection, it means that there is a problem with the configuration. Please check the relevant configuration.

腾达路由器WAN口状态

Friendly reminder:After the configuration is completed, the Windows 8 computer connected to the Tengda router can directly access the Internet, and there is no need to make a dial-up connection on the Windows 8 computer.

Related articles:

1、Tenda’s wireless router cannot be connected to the Internet after setting up

2、Tenda router limits WiFi speed 

3. How to set up Tengda wireless router (Windows 7 system) 

Post a reply

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注