Tenda FS395 router automatically obtains IP(DHCP) Internet settings

This article introduces the automatic IP acquisition (DHCP) Internet access setting method for Tenda FS395 router. The automatic IP acquisition (DHCP) Internet access setting method described in this article is suitable for users who: when not using the router, plug the network cable provided by the broadband carrier into the computer, and set the computer’s IP address to automatic acquisition to access the Internet.

Step 1: Install Tengda FS395 router

Users need to be prepared1 pieceNetwork cable, one end of the network cable is connectedcomputer, the other end is connected to the Tengda FS395 router1/2/3Any of the interfaces; and then connect theHousehold network cablePlugged into the Tengda FS395 routerWANInterface.

网线入户上网时路由器的安装方法

Warm reminder:

The normal working state of the Tengda FS395 router is that the indicator light SYS flashes, the WAN port is always on or flashing, and the port connected to the computer in the 1/2/3 port is always on or flashing.

Step 2: Set your computer IP address

Before setting up the Tengda FS395 wireless router, we need to set the IP address of the computer toautomatic acquisition, as shown in the following figure. If you don’t know how to set it, please read the article: Computer Dynamic (Automatic Acquisition)IP Address Setting Method.

电脑IP地址设置为自动获取

Step 3: Tengda FS395 router automatically obtains IP(DHCP) Internet settings

1. Enter: 192.168.0.1 in the browser’s address bar and press the Enter button to enter the default login password: admin Click OK.(If 192.168.0.1 cannot be opened, please read the article:Solution to the Tenda wireless router 192.168.0.1 that cannot be opened

登录腾达FS395路由器的设置界面

2. Click Internet settings to select the networking method: dynamic IP settings wireless signal name, wireless password and click OK.

腾达FS395路由器自动获取IP(DHCP)上网设置

Warm reminder:“Please use letters and numbers for wireless signal names, and cannot use Chinese and special characters. Some devices do not support Chinese, and Chinese wireless signal names cannot be searched.

Step 4: Check whether the automatic IP acquisition (DHCP) Internet access setting is successful

If the connection status under the networking information shows: Connected, as shown in the following figure. This shows that the Tengda FS395 router has successfully obtained IP(DHCP) Internet access settings.

检查腾达FS395路由器自动获取IP上网设置是否成功

At this point, we have completed the automatic acquisition of IP(DHCP) Internet access settings by the Tenda FS395 router, and the computer can directly access the Internet.t have tothen through“broadband connection”Dial-up access.

If there are other computers that need to surf the Internet, directly connect the computer to any idle interface of the router 1/2/3, and set the IP address to automatic acquisition to access the Internet; just connect the wireless device to the WiFi signal of the FS395 router.

Related articles:

1、Tenda’s wireless router cannot be connected to the Internet after setting up

2. ADSL Internet settings for Tenda FS395 router

3、Tenda router limits WiFi speed

Post a reply

发表回复

您的电子邮箱地址不会被公开。 必填项已用 * 标注